Differential Installation - New Holland T8010 Manual

STEP 68
Install ring gear and differential assembly with
bearing cups into carrier housing.
IMPORTANT: Care should be used when installing
ring gear and differential into carrier housing so
damage to ring gear, pinion bearings, or bearing bore
does not occur.
STEP 69
3
1
1. BEARING CUP
Install adjusting rings in place. Thread in adjusting
rings until all slack is removed between bearing cups
and bearings.
NOTE: Adjusting rings must be installed with side of
nut having the deeper recess facing the bearing.
Installed opposite, the adjusting ring would clamp
against the bearing cage restricting movement.
NOTE: Right hand adjusting ring shown.
Section 25 - Four-Wheel Drive Front Axle - Chapter 9

DIFFERENTIAL INSTALLATION

RD06A146
RD02J018
2. ADJUSTING RING
25-9-23
STEP 70
Be sure bearing cups are seated on bearing cones,
then install differential bearing caps. Install bearing
cap bolts (finger tight only) so adjusting nut can still
be turned. (Do not torque cap bolts to specifications).
NOTE: Make sure the "match marked" bearing cap
and "match marked" leg of the carrier are aligned.
STEP 71
B
1. DIAL INDICATOR
Position a dial indicator on the housing lip and index
indicator dial to back face of the ring gear. Zero the
indicator.
Mesh ring gear and pinion to zero backlash by
loo sen ing adj usti ng nut (A ) (n ot s hown) an d
tightening adjusting nut (B). (Ring gear is moved into
mesh with pinion).
RD02J019
1
2
RD02J020
2. ADJUSTING RING