New Holland T8010 Manual page 576

Hide thumbs Also See for T8010:

Table of Contents

While tightening the nut, make sure the seal is

squarely aligned on the spindle. Continue advancing

the nut until a noticeable increase in torque is noted.

There may be a very small gap (1) (0.025 to 0.50

MM.) between the seal and the spindle shoulder.

This is a normal condition.

Once the seal is installed, use both hands to rotate

the outer portion of the seal. The seal should turn,

but may require some effort.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

GRAPHIC_ID_NUMBER

Remove all the installation tools except the for the

flanged tool (1). Install the bearing cone onto the

Apply a THIN film of oil on the OD of the seal. Spread

the oil evenly around the entire seal area.

Install the hexagon adapters to the wheel studs 180

degrees apart. Tighten the adaptors.

Chapters

Table of Contents

T8020 T8030 T8040