REMOVAL OF THE FRONT DIFFERENTIAL FROM THE CARRIER HOUSING
STEP 6
Place the carrier housing on a clean work surface.
STEP 7
Remove the three socket head screws from the seal
retainer. (3 mm Allen wrench).
STEP 8
Remove the bolt and washer locking the adjusting
nut in place.
Section 25 - Four-Wheel Drive Front Axle - Chapter 9
RD06A137
RD06A138
RD06A139
STEP 9
Remove the seal retainer.
STEP 10
Mark the bearing cap.
STEP 11
Remove bearing cap retaining bolts and washers
then remove bearing cap. (24 mm or 15/16 inch
socket).
25-9-5
RD06A140
RD06A141
RD06A142