New Holland T8010 Manual page 650

Hide thumbs Also See for T8010:

Table of Contents

Apply Loctite 290 to seal the area between the axle

bushing and axle.

Apply Loctite 609 to the OD of the axle bushing.

Section 27 - Rear Axle - Chapter 1

Install the wear sleeve as follows:

1. Heat the new wear sleeve in a bearing oven to

2. Install the sleeve onto the axle bushing with the

NOTE: If the wear sleeve is driven onto the axle

bushing, make sure that the sleeve does not touch

and preload the axle bearing.

191° to 204°C (375° to 400°F).

WARNING: Always wear heat protective

gloves to prevent burning your hands when

handling heated parts.

OD chamfer to the outside. The wear sleeve

must just touch or be no more than 0.51 mm

(0.020 inch) away from the axle bearing.

Chapters

Table of Contents

T8020 T8030 T8040