New Holland T8010 Manual page 674

STEP 3
Remove the third link support/PTO clutch cover plate
and gasket. Discard gasket.
STEP 4
The PTO manifold plate (1) and speed sensor (2) are
located on the rear frame cover plate between the
r e m o t e v a l v e s a n d r e m o t e v a l v e c o u p l e r s .
Disconnect the wire harness (3) from the speed
sensor and remove the sensor (2). Remove the PTO
manifold plate (3).
NOTE: Hitch rock shaft removed for photographic
purposes.
STEP 5
Remove the PTO jumper tubes (1). Remove the O-rings
(2) from both ends of each tube and discard. Remove
the manifold plate O-ring seals (3) and discard.
STEP 6
Remove the two upper PTO assembly mounting
bolts.
NOTE: Hitch components and draw bar rear support
are removed for photographic purposes.
Section 31 - PTO - Chapter 2
31-2-5
3
1
2
1
3
RD05A014
2
RD05A011
RD05A012
RD05A046