New Holland T8010 Manual page 294

Hide thumbs Also See for T8010:

Table of Contents

Turn shaft over. Install the needle thrust bearing and

the two bearing thrust washers. The needle thrust

bearing must be between the two bearing thrust

Remove the clutch piston from the clutch plate

carrier. If necessary, hit the low range driven gear

and clutch plate carrier against a wooden block to

remove the clutch piston.

Section 21 - Transmission, Drivelines - Chapter 6

Remove the teflon ring (1) and O-ring (2) from the

carrier (3) and piston (4). Install the new O-ring in the

groove. Install the new teflon ring over the O-ring.

Put petroleum jelly on the rings.

Chapters

Table of Contents

T8020 T8030 T8040