New Holland T8010 Manual page 811

Removal
STEP 3
3
1
1. INLET
2. LUB INLET
3. PTO PWM SOLENOID
NOTE: Clean the surface of the PTO valve and all
tube connections before doing any service work. Tag
tube and electrical connections. Cap or plug all open
hydraulic connections.
NOTE: Depending on how your tractor is equipped,
it may be necessary to remove hydraulic tubes that
run across the top of the valve in order to remove the
valve.
1. Disconnect the tube from the valve inlet (1).
2. Disconnect the tubes from the lube inlet (2).
3. Disconnect the wire harness from the PTO PWM
solenoid (3).
4. Disconnect the wire harness from the diff lock
solenoid (4).
5. Remove the two mounting bolts (5) and remove
the valve from the mounting plate.
Section 35 - Hydraulic Systems, 3PT - Chapter 3
2
5
4
35-3-4
4. DIFF LOCK SOLENOID
5. MOUNTING BOLT
RI02D105