New Holland T8010 Manual page 686

STEP 43
Press bearing cup into bearing carrier.
STEP 44
Press second cup into bearing carrier.
STEP 45
Press bearing onto the PTO drive shaft. Make sure
the bearing is seated against the bearing spacer.
NOTE: DO NOT press on the bearing cage. DO
NOT overpress or deflection of the retaining ring will
occur. This will affect the shimming.
STEP 46
Apply petroleum jelly or Lubriplate® to the seal rings
and install. Make sure each seal is properly locked
after placing in the groove.
Section 31 - PTO - Chapter 2
31-2-17
RD05D011
RD05D012
RD05D006
RD05B042