New Holland T8010 Manual page 313

Hide thumbs Also See for T8010:

Table of Contents

Hand press the piston onto the hub to "size" the seal

rings. Remove the piston and set aside.

Place the hub (upside down from normal installation)

over the shaft. Make sure the hub splines are

engaged in the shaft splines and sitting squarely on

the PVC pipe.

Install the backing plate. Make sure the wide cutout

(1) is facing downward.

Section 21 - Transmission, Drivelines - Chapter 6

Install a friction plate.

Install a separator plate. Alternate separator and

friction plates until all six separator and six friction

plates are installed.

NOTE: Once all spacers and friction plates are

installed, rotate the hub in one direction ONLY, to get

clearance. This will aid in the removal and installation

of the hub assemblies in later steps.

Chapters

Table of Contents

T8020 T8030 T8040