New Holland T8010 Manual page 501

Hide thumbs Also See for T8010:

Table of Contents

Be sure the plates are arranged for installation as

3 Plates (in board side)

Install the plate/disc stack into the differential

housing. Install the dished disc into the differential

housing. The convex side of the disc must be up so

the ID of the disc makes contact with the side gear

that is installed next.

Section 25 - Four-Wheel Drive Front Axle - Chapter 8

Apply grease to the shoulder of the side gear, then

install the side gear in dished disc in the flanged

housing half.

Lubricate the pinion mate gear ID's. Install the pinion

mate gears and thrust washers.

NOTE: Make sure the shafts are installed in the

same order as disassembly. Refer to the alignment

marks made prior to disassembly.

Place the side gear on top of the pinion gears.

Chapters

Table of Contents

T8020 T8030 T8040