New Holland T8010 Manual page 527

Hide thumbs Also See for T8010:

Table of Contents

Remove the spacer (ten bolt only) from the pinion

shaft as shown.

Remove pinion adjustment shims from the pinion

Section 25 - Four-Wheel Drive Front Axle - Chapter 9

Remove the inner bearing cup.

NOTE: Shims are located between the bearing cup

and carrier bore. If shims are bent or nicked, they

should be replaced at time of assembly. Wire the

stacks together and measure each. If a stack is

replaced, replace with the same thickness.

Remove inner bearing adjustment shims.

Chapters

Table of Contents

T8020 T8030 T8040