New Holland T8010 Manual page 373

STEP 83
Determine dimension as follows:
1. Apply 50 to 100 lbs forward loading on the pinion
shaft to remove all bearing end play.
2. Measure from the face of the pinion shaft to the
face of the depth setting tool bar in millimeters.
This is your measured dimension.
3. Subtract this measurement from the desired
dimension calculated in Step 80.
Example:
034.14 mm Desired Dimension
-33.82 mm Measured Dimension
0.32 mm Shim Pack Size
4. Shims are available in the following sizes:
0.003, 0.004, 0.005 and 0.012 inches (0.076,
0.10, 0.13, and 0.30 mm).
STEP 84
Remove the pinion shaft assembly from the housing.
Section 21 - Transmission, Drivelines - Chapter 8
T98202
T95912
21-8-22
STEP 85
Select the correct shim pack, determined in Step 83,
within 0.03 mm (0.001 inch). Install the shims over
the alignment dowels.
STEP 86
Select the correct shim pack, determined in Step 83,
within 0.03 mm (0.001 inch). Install the shims over
the alignment dowels.
T95913
T95913