STEP 41
2
1
2
Apply a thin coat of anti seize lubricant to the
transmission input shaft splines. Properly support the
engine and lift into place. Align the splines on the
shaft with the engine flywheel dampener and slide
into place. Install the mounting bolts. Tighten the two
M20 bolts (1) to a torque of 430 to 485 Nm (315 to
355 lb. ft.) Tighten the four M16 bolts (2) to a torque
of 221 to 250 Nm (160 to 180 lb. ft.).
Section 10 - Engine - Chapter 1
ENGINE INSTALLATION
STEP 42
RD05N135
Set the hose / tube / air cleaner support bracket
assembly in place on top of the engine.
STEP 43
2
1
2
RI02C011
Set the spacer (1) into place and install the mounting
bolts (2).
NOTE: DO NOT tighten the bracket mounting
hardware at this time.
10-1-10
RD05N133
2
1
RD05N132