New Holland T8010 Manual page 541

STEP 72
B
A
Section 25 - Four-Wheel Drive Front Axle - Chapter 9
1
RD02J023
RD02J028
RD02J025
25-9-24
A
Position dial indicator (1) on lip of differential housing
and indicate to side of one tooth on ring gear.
L o o s e n a d j u s t i n g n u t ( B ) u n t i l b a c k l a s h i s
approximately 0.127 mm (0.005 inch). Continue
loosening adjusting nut (B) until adjusting ring cap
bolt, washer and clip can be installed. Torque bolt to
27 to 40 Nm (20 to 30 lb. ft.). Tighten all of the
bearing cap bolts to a torque of 240 to 270 Nm (180
to 200 lb. ft.).
Tighten adjusting nut (A) to a torque of 75 to 88 Nm
(55 to 65 lb. ft.) (with the differential locknut wrench
tool). Which will result in a bearing preload of 1.13 to
2.26 Nm (10 to 20 lb. inch). (When measured through
the pinion will read 2.5 to 5 lb. inch more than the
original pinion torque setting).
Install the bolt and washer for adjusting nut (A) and
torque to 27 to 40 Nm (20 to 30 lb. ft.). Advance to
next hole if required.
Final backlash to be 0.076 to 0.3 mm (0.003 to 0.012
i nc h ) ( 0 .1 27 t o 0 .2 m m [0. 00 5 t o 0. 00 8 i nc h ]
preferred).
RD02J024
RD02J116