New Holland T8010 Manual page 180

Hide thumbs Also See for T8010:

Table of Contents

Install a separator plate. Install the remaining seven

new fr ic tion pl ates and six se parator pla te s,

alternating the plates.

Install the backing plate. The flat side of the plate

must be facing down.

Install the snap ring.

Section 21 - Transmission, Drivelines - Chapter 4

Put the carrier assembly in a press. Align the oil hole

in the carrier with the oil gallery hole in the shaft.

Press the shaft into the carrier until fully seated.

NOTE: Be sure the oil holes in the shaft and carrier

are aligned before proceeding.

Install the carrier retaining snap ring.

Chapters

Table of Contents

T8020 T8030 T8040