STEP 153
1. MARK ON FACE OF
CARRIER
Remove the snap ring. Make a mark on the carrier
face that will align with the mark on the end of the
shaft. These marks will be used to align the carrier
on the shaft during assembly.
NOTE: If a new part replaces an old part, make a
mark on the new part that is in the same position as
the mark for the old part.
Section 21 - Transmission, Drivelines - Chapter 4
T95410
1
2
468L72
2. MARK ON FRONT END
OF SHAFT
STEP 154
Remove the clutch plate carrier from the shaft.
STEP 155
Remove the snap ring from the clutch plate carrier.
STEP 156
Remove the backing plate, friction plates, separator
plates and reaction plate.
21-4-45
A11559
A11560
A11561