New Holland T8010 Manual page 943

Hide thumbs Also See for T8010:

Table of Contents

NOTE: Be sure to remove the M8 nut that attaches

the link to the position locator bracket located on the

After the linkage shield for the potentiometer (hitch

position sensor) is removed. The potentiometer

subassembly can be removed as a unit.

Remove the three nuts holding the sensor, bracket

an d bu s hi ng to ge th er. S e pa ra te t he s e th r e e

Remove the E-ring from each side of

the bushing.

Remove the link from the bushing.

Section 35 - Hydraulic Systems, 3PT - Chapter 11

Lubricate the link and slide it into the bushing as far

as possible. Install an E-ring on the backside of the

Pull the link back until the E-ring bottoms out. Install

the second E-ring.

Hold the bushing and link subassembly. Position the

bend in the link over the corner that does not have a

bolt. Insert the three bolts into the bushing. Slide the

bracket over the three bolts. Slide the potentiometer

over the bolts. Position the tip of the link into the slot

as the potentiometer slides into position. The link

should be positioned as the parts are assembled (as

shown in Section A-A).

Install the three nuts and tighten to a torque of 3.5 to

6.3 Nm (2.6 to 4.6 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040