New Holland T8010 Manual page 698

STEP 87
Place the clutch assembly on the CAS-1995-6 guide
pins (1) and slide into place. Install the two lower
mounting bolts (2).
NOTE: Clutch assembly may have to be rotated
slightly to align the splines of the clutch drive shaft
with the countershaft.
STEP 88
Remove the guide pins and install the two upper
mounting bolts.
STEP 89
Install new O-rings on both ends of the jumper tubes
(1) and push into place. Install new O-ring seals (2).
STEP 90
Install the PTO manifold plate (1) and speed sensor
(2). Reconnect the speed sensor wire harness (3).
Section 31 - PTO - Chapter 2
1
1
1
1
31-2-29
1
2
3
3
1 1
2
3
1
3
3
RD05A047
RD05A046
RD05A012
2
RD05A011