New Holland T8010 Manual page 283

Hide thumbs Also See for T8010:

Table of Contents

Remove the compression sleeve. Check to make

sure the snap ring is properly seated in the groove on

Install the clutch plate snap ring on top of the gear.

Install the backing plate. The flat side of the plate

must be facing up.

Section 21 - Transmission, Drivelines - Chapter 6

Install a friction plate.

NOTE: Dip all friction plates in clean transmission

Install a separator plate. Install the remaining 10

friction plates and 10 separator plates, alternating the

p l a t e s. W h e n eve r t h e c l u t c h p a ck h a s b e e n

disassembled, new friction plates must be installed.

Chapters

Table of Contents

T8020 T8030 T8040