New Holland T8010 Manual page 691

Hide thumbs Also See for T8010:

Table of Contents

Place the retaining ring (1) over the clutch pack hub.

Using Special Tool 380002454, compress the brake

holder plates until the retaining ring is fully seated

into the groove.

NOTE: Make sure the cutouts (2) of the tool are NOT

over the brake adjuster pins (3). Tool has to push the

brake adjuster pins flush with the holder plate (4) to

allow the retaining ring to seat into the groove.

IMPORTANT: Before removing the compression

tool, make sure the retaining ring is fully seated into

the ring groove and is not touching the adjuster pins.

Tur n the hub over and GENTLY tap the brake

adjuster pin as shown. If pin does not move, the

retaining ring will be set into the pin groove.

If needed, turn the assembly over and gently drive

brake adjuster pins down until the retaining ring is

locked into the groove on the pin.

Section 31 - PTO - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040