New Holland T8010 Manual page 177

5. Heat the (3rd-4th) speed drive gear (5) in a
bearing oven for 3 to 4 hours at a temperature of
350 to 370° F (177-187° C).
NOTE: Do not heat the gear beyond a temperature
of 375 ° F (190° C).
6. Install the gear (5) over the shaft, engaging the
ball and seat against the (1st-3rd-5th) speed
driven gear.
7. Install the snap ring. The flat side of the snap ring
must face away from the gear.
8. Apply petroleum jelly to the third steel ball (3)
and install into the shaft hole for (1st-2nd) speed
driver gear.
9. Heat the (1st-2nd) speed driver gear (1) in a
bearing oven for 3 to 4 hours at a temperature of
350 to 370° F (177 to 187° C).
NOTE: Do not heat the gear beyond a temperature
of 375° F (190° C).
10. Install the gear (1) over the shaft, engaging the
ball and seat against the shaft shoulder.
STEP 35
Install the bearing cone over the shaft with the larger
OD end of the bearing seated against the gear. Press
the bearing on the inner race to properly seat the
bearing on the shaft.
Section 21 - Transmission, Drivelines - Chapter 4
A11504
21-4-16
STEP 36
Apply petroleum jelly to the steel ball and install in
the shaft hole.
STEP 37
Heat the (2nd-4th-6th) speed driven gear in a bearing
oven for 3 to 4 hours at a temperature of 350° to
370°F (177° to 187°C).
NOTE: Do not heat the gear beyond a temperature
of 375°F (190°C).
WARNING: Always wear heat protective
gloves to prevent burning your hands when
!
handling heated parts.
A22753
T95275
SM121A