Axle Housing Disassembly - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Remove the nylon wear insert from the axle shaft

end. Remove the retaining ring from the axle shaft.

Press on the thrust ring to relieve pressure on the

retaining ring before removing retaining ring from

Remove the thrust ring from the axle shaft.

Section 27 - Rear Axle - Chapter 1

AXLE HOUSING DISASSEMBLY

Remove the shims from the axle shaft.

Install a pulling bridge and a 30-ton ram on the axle

housing. Press the axle assembly out of the axle

Remove the seal and, if equipped, the wear sleeve,

from the axle shaft.

Table of Contents

T8020 T8030 T8040