STEP 22
When both rockshaft pins are removed, lift and set
aside the rockshaft casting.
NOTE: Keep bearings and seals free of foreign
material.
STEP 23
While both hitch support C-brackets are still firmly
held in place, attach a sling and hoist to the large pin
bearing hole in one of the hitch support arms. Take
the slack out of the sling, but do not lift up on the
bracket. If bushings and seals are not going to be
replaced, use care not to damage seal or bushing nor
contaminate them with dirt, grease or oil.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
35-14
35-10
35-11-12
STEP 24
Remove the seven attaching bolts that pass through
the hitch support C-brackets into the rear frame
housing.
STEP 25
Lift off and set aside the hitch support C-bracket.
STEP 26
Repeat Steps 26 through 28 for the other hitch
support arm.
35-8
35-5