New Holland T8010 Manual page 303

STEP 197
Support the gear/can weldment (1) as shown and
press the FWD/park brake shaft (2) free from the
weldment. Remove the bearing.
IMPORTANT: Make sure that the shaft dose not
strike the floor once it is pressed free from the
weldment, as damage to the shaft may occur.
IMPORTANT: Mark the bearing for location. If
bearing is to be reused it MUST be reinstalled with
the same bearing cup.
STEP 198
Remove the second bearing from the shaft.
IMPORTANT: Mark the bearing for location. If
bearing is to be reused it MUST be reinstalled with
the same bearing cup.
Section 21 - Transmission, Drivelines - Chapter 6
2
1
RD05K043
RD05K044
21-6-50
STEP 199
2
Using a soft drift (1), remove the bearing cup (2).
STEP 200
Repeat for the second bearing cup.
STEP 201
Remove snap rings if needed.
1
RD05K045
RD05K046
RD05K046