New Holland T8010 Manual page 279

STEP 85
Install the first piston return Belleville spring. The
concave side of the spring must be facing down.
STEP 86
Install the lube management ring.
Install additional Belleville springs as follows:
1. Install a second Belleville spring. The concave
side of the washer must be facing up.
2. Install the remaining
alternating the position of the springs until the
last washer with the concave side is facing down.
Section 21 - Transmission, Drivelines - Chapter 6
RD05K110
RD05K109
A10887
6 Belleville springs,
21-6-26
STEP 87
2
1
1. Install a snap ring (1) over the shaft.
2. Install the Belleville spring compression sleeve
CAS1903-5 (smaller OD up) over the shaft and
on top of the snap ring.
STEP 88
Install the snap ring as follows:
1. Install the compression sleeve with the notch
CAS1903-3.
2. Use a hydraulic press to press the compression
sleeve down onto the shaft.
3. The snap ring will slip into position in the groove.
4. Check to be sure that the snap ring is properly
seated in the groove on the shaft.
A10899
A10900