New Holland T8010 Manual page 243

STEP 290
Remove the rear bearing cage. Take the average
measurement from Step 275. To this average
measurement, add the following amount of shims
thickness:
Input Shaft without Creep Drive 0.009 in. (0.229 mm)
Input Shaft with Creep Drive..... 0.008 in. (0.203 mm)
Countershaft without Creep Drive ............. 0.014 inch
Countershaft with Creep Drive .................. 0.008 inch
Output Shaft ............................. 0.014 in. (0.356 mm)
The result is the correct shim pack thickness. Select
a measured shim pack having a thickness within
0.001 inch (0.025 mm) of the desired value.
STEP 291
Install the measured shim pack and the rear bearing
cage. Tighten the bolts to a torque of 54 to 61 Nm (40
to 45 lb. ft).
Section 21 - Transmission, Drivelines - Chapter 4
SCH309
(0.356 mm)
(0.203 mm)
SCH310
21-4-82
STEP 292
Do the following:
1. Rotate the shaft a minimum of 12 revolutions.
2. Use a dial indicator to measure the end play.
3. Use a pry bar inside the speed transmission
housing to lift a gear on the shaft.
4. The end play must be 0.001 to 0.005 inch (0.03
to 0.13 mm).
5. Add or remove shims to get a correct reading.
NOTE: Measure the end play of all three shafts
following the procedure in Steps 273 through 278.
Check one shaft at a time.
SCH311