New Holland T8010 Manual page 385

STEP 138
Insert the slotted end of a locking flag plate into the
groove on the inside of the hitch swivel pin.
STEP 139
Install the hex-head bolt and tighten it to a torque of
82 to 106 Nm (60 to 78 lb ft). Repeat for the other
vertical lifting link.
NOTE: Refer to Tractor Hitch in this manual for
details about orienting the links in the three-point
hitch if they were removed.
STEP 140
When the rockshaft is fully assembled, calibrate the
hitch (see Hitch Controller Calibration and Fault
Codes in this manual for the procedure).
Section 21 - Transmission, Drivelines - Chapter 8
26s24b
26s21b
21-8-34
STEP 141
Install and tighten the rear frame drain plug in the
housing.
STEP 142
Install the drawbar on the tractor and secure with the
pin. Torque the pivot pin retaining bolt to 125 to 150
Nm (93 to 112 lb ft). Refer to Tractor Hitch in this
manual for details.
STEP 143
Install the brake cylinders onto the tractor.
STEP 144
Install the axle shafts and planetaries on the tractor.
STEP 145
Connect the range transmission and the rear frame
together (refer to Range Transmission to Differential
Split in this manual).
STEP 146
Install the fuel tank on the tractor.
STEP 147
After filling the transmission, operate the tractor for a
few minutes. Shut down and check the transmission
fluid level.
STEP 148
If not already performed, calibrate the hitch (see
Hitch Controller Calibration and Fault Codes in this
manual).
91s16