New Holland T8010 Manual page 225

Hide thumbs Also See for T8010:

Table of Contents

Install the snap ring as follows:

1. Install the compression sleeve CAS1903-3 with

the notch over the shaft.

2. Use a hydraulic press to press the sleeves down.

The snap ring will be pushed into position in the

3. Verify that the snap ring is seated properly in the

Put the clutch pack retaining ring on top of the gear.

Section 21 - Transmission, Drivelines - Chapter 4

Install the backing plate over the gear.

NOTE: The flat side of the place must be facing up.

Install a new friction plate.

NOTE: Dip all friction plates in clean transmission

Install a separator plate.

Chapters

Table of Contents

T8020 T8030 T8040