New Holland T8010 Manual page 536

STEP 54
Install the bearing caps and cap bolts. Tighten the
bolts to a torque of 244 to 271 Nm (180 to 200 lb. ft.)
(Use a 24 mm socket).
STEP 55
Position Gauge Block CAS-1898-4 under Tube CAS-
1898-6. Use a feeler gauge and measure the
distance between the tube and the block. This
dimension is the shim thickness needed, provided
the pinion shaft has not "+" or "-" marking n the button
end.
STEP 56
If the pinion shaft has a "+" marking, subtract the
amount shown from the measurement taken in Step
55. The remainder is your shim pack thickness.
If the pinion shaft has a "-' marking, add the amount
shown to the measurement taken in Step 55. The
sum will be your shim pack thickness.
NOTE: The "+" and "-" markings on the pinion shaft
are given in thousandths of an inch. Shims are
available in thicknesses of 0.076 mm (0.003 inch),
0.127 mm (0.005 inch), 0.25 mm (0.010 inch).
Acceptable tolerance is 0.050 mm (+/-0.002 inch) of
number etched on
calculation).
Section 25 - Four-Wheel Drive Front Axle - Chapter 9
T98522
T98523
pinion shaft (total shim
STEP 57
Remove the depth setting tool CAS-1898 from the
carrier housing.
STEP 58
If necessary to adjust pinion position, remove the
inner bearing cup.
STEP 59
Install the proper amount of shims.
25-9-19
T98489
T98491