STEP 13
M e a s u r e a n d r e c o r d t h e d i s t a n c e f r o m t h e
straightedge to point "B". The difference between
measurements "A" and "B" must not exceed 1mm.
M e a s u r e m e n t " A " s h o u l d n o t b e l a r g e r t h a n
measurement "B".
STEP 14
If adjustment is necessary, loosen the tie rod tube
locking nut (1). Disconnect the steering lines from the
outboard ends of both steering cylinders to avoid
repositioning of the axle.
Tu r n th e tube ( when v iewed fr om the wheel)
clockwise to shor ten the tie rod. Turn the tube
counterclockwise to lengthen the tie rod.
NOTE: Check to be sure that the axle is still "Dead
Centered" after the tie rod had been adjusted. If the
axle has moved from the dead center position, the
steering cylinder lines will have to be connected and
the axle must be steered back to dead center.
Check measurements "A" and "B" again with the axle
dead centered. If the measurements are within
specification, repeat the procedure on the other side
of the tractor.
Section 41 - Steering - Chapter 2
41-2-7
RD05E089
1
RD05E093