New Holland T8010 Manual page 688

STEP 51
Install the retaining ring.
STEP 52
Back press the bearing cone against the shims,
s p a c e r a n d r e t a i n i n g r i n g . B a ck p r e s s i n g i s
accomplished by supporting the bearing cage (1) on
the rear flange face (2) and pressing down against
the front of the shaft (3) where the internal spline is.
NOTE: DO NOT overpress or deflection of the
spacer and retaining ring will occur. This will affect
the shimming.
STEP 53
Check end play. End play should be between 0.001
t o 0 . 0 0 5 i n c h e s . I f e n d p l ay i s n o t c o r r e c t ,
disassemble and adjust the shim pack, assemble
and check end play again.
STEP 54
Install the first brake apply disc spring. Make sure
spring fingers (1) are pointed toward the hub gear (2).
Section 31 - PTO - Chapter 2
1
31-2-19
3
1
2
1
3
RD05B037
RD05B040
RD05D022
2
RD05N152