New Holland T8010 Manual page 227

STEP 239
1. FRONT FACE OF CARRIER
2. MARK
3. FRONT FACE OF SHAFT
Before installing the front clutch plate carrier on the
shaft, find the mark made in Step 146 on the front
face of the carrier and on the front end of the shaft.
Section 21 - Transmission, Drivelines - Chapter 4
1
2
3
2
434L7
STEP 240
Install carrier as follows:
1. Install the rear face of the carrier over the front
end of the shaft.
2. Align the marks on the carrier and the shaft
before pushing the carrier down on the shaft.
NOTE: Aligning the marks will align the oil holes in
the shaft with the oil holes in the carrier.
3. Align the separator plate tabs with the slots in the
carrier.
4. Use a press if necessary to carefully push the
carrier down on the shaft.
5. Check to be sure that the oil holes in the shaft
and carrier are aligned. Look through the oil hole
in the carrier and almost a full hole in the shaft
should be visible.
STEP 241
Install the carrier snap ring over the shaft.
21-4-66
T95413
T95503