New Holland T8010 Manual page 438

Hide thumbs Also See for T8010:

Table of Contents

Remove the shim(s). The bearing spacer is shown

with two shims.

NOTE: Keep the shim(s) with the bearing cage.

Remove the bearing cage as follows:

1. Rest the bottom of the drive shaft on a wooden

2. Hold the bearing cage.

3. Tap downward on the ears of the bearing cage in

a crossing pattern.

4. Remove the front bearing cup.

5. Remove the bearing cage.

Section 25 - Four-Wheel Drive Front Axle - Chapter 3

Remove the rear bearing cup from the bearing cage,

as shown in drawing above.

Press the front bearing cone from the output shaft.

Remove the external retaining ring.

Chapters

Table of Contents

T8020 T8030 T8040