New Holland T8010 Manual page 444

Hide thumbs Also See for T8010:

Table of Contents

Measure from the end of output shaft to the surface

of yoke. Select a shim combination to obtain a

distance of 0 to 0.1 MM. (0 to 0.004 inch).

Install the shims and the yoke retaining bolt washer.

Section 25 - Four-Wheel Drive Front Axle - Chapter 3

Place the FWD output shaft in a vise and install the

yoke retaining bolt. Apply a torque of 252 to 280 Nm

(186 to 206 lb. ft.) to the bolt.

NOTE: Do not install the output shaft if the FWD

clutch is to be serviced. Refer to FWD Clutch

Removal found in the Range Section of this Repair

Install the FWD output shaft and bearing cage into

the housing.

IMPORTANT: The output shaft engages a needle

bearing in the rear wall of the speed transmission

housing. Be careful not to dislodge the bearing.

Chapters

Table of Contents

T8020 T8030 T8040