New Holland T8010 Manual page 321

Hide thumbs Also See for T8010:

Table of Contents

Press a new cup into the bore of the input shaft

bearing cage until the cup seats against the cage

Install a new seal ring on the input shaft bearing

Section 21 - Transmission, Drivelines - Chapter 6

Install a snap ring pliers through the opening in the

hydraulic pump drive gear which is installed on top of

the range transmission countershaft bearing cage.

Move the snap ring out of the groove that is in the

bearing cage.

Remove the hydraulic pump drive gear.

Use a puller to remove the bearing cup from the

range transmission countershaft bearing cage.

Chapters

Table of Contents

T8020 T8030 T8040