New Holland T8010 Manual page 182

STEP 56
Align the friction plate teeth. Install the creeper driven
gea r in to the c lu tch c ar r ie r as s embly. S l igh t
oscillation of the gear will help with the installation.
The splined hub of the gear must engage all the
friction plates.
STEP 57
Install the caged needle bearing. The top of the needle
bearing cage will be aligned with the top of the gear
hub when all the friction plates are engaged on the hub.
STEP 58
Install the needle thrust bearing and the two bearing
thrust washers. The needle thrust bearing must be
between the two bearing thrust washers.
Section 21 - Transmission, Drivelines - Chapter 4
T95296
A11512
A11513
21-4-21
STEP 59
Install the bearing cone with the larger OD bearing
end facing down. Press the bearing on the inner race
to properly seat the bearing on the shaft.
STEP 60
Install two new seal rings on the rear of the shaft.
STEP 61
Disassemble and assemble the countershaft using
the illustrations provided. For disassembly, follow
Steps 23 to 26. For assembly, follow Steps 32 to 36.
A11514
T95237