New Holland T8010 Manual page 689

Hide thumbs Also See for T8010:

Table of Contents

Install the second brake apply disc spring. Make sure

spring fingers (1) are pointed away from the hub gear (2).

Discs should be installed as shown.

Install the first brake holder plate. Make sure the tabs

(1) are pointed away from the disc spring (2).

Set the retainer ring (1) on the brake adjuster pin (2)

so that it is approximately 1/2 inch from the end of the

pin. Repeat with the other pins.

Section 31 - PTO - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040