Installation
STEP 65
Install the pin retainer and washer; tighten the bolt to
a torque of 134 to 151 Nm (99 to 111 lb. ft.). Install
the drawbar support (assist casting) under the
drawbar as shown.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
35-11-27
STEP 66
Tighten the three M20 x 150 bolts to a torque of 485
to 620 Nm (358 to 458 lb. ft.). Install the spacers and
hammerstrap. Install the two M20 x 260 bolts and
tighten to a torque of 486 to 620 Nm (358 to 458 lb.
ft.). Install two M20 x 220 bolts to and tighten to a
torque of 485 to 620 Nm (358 to 458 lb. ft.). Install the
hammerstrap pin and cotter pin. If hammerstrap latch
was removed, tighten the bolt to a torque of 71 to 128
Nm (52 to 94 lb. ft.).