New Holland T8010 Manual page 307

Hide thumbs Also See for T8010:

Table of Contents

Support the gear (1) as shown. Backseat the bearing

against the retainer ring. DO NOT over press.

IMPORTANT: Over pressing the bearing may distort

the retainer ring which may cause improper shaft end

play. Improper end play may cause premature

bearing failure.

Check the shaft end play.

1. Place a dial indicator on the shaft.

2. Carefully pry up between the FWD gear and

shaft flange.

3. Shaft end play: 0.089 mm (.0035 inch) +/- 0.064

mm (.0025 inch).

4. Add or subtract shims as needed.

5. Recheck end play if shims are changed.

NOTE: Do not install seals at this time.

Section 21 - Transmission, Drivelines - Chapter 6

Install the retainer ring.

Install a backing plate. Make sure the larger cutout

(1) is facing the retainer ring.

Install a friction plate.

Chapters

Table of Contents

T8020 T8030 T8040