New Holland T8010 Manual page 383

Hide thumbs Also See for T8010:

Table of Contents

Install the nut that attaches the position locator

bracket to the end of the tie rod. Tighten to a torque

of 490 to 555 Nm (362 to 410 lb. ft.). The nut on the

opposite end of the tie rod will need to be held with a

wrench to achieve torque.

Install the two bolts that attach the rockshaft sensor

shield to the hitch support arm. Tighten to a torque of

62 to 80 Nm (46 to 59 lb. ft.).

NOTE: Refer to Tractor Hitch in this manual for

details about adjusting the hitch support system.

Section 21 - Transmission, Drivelines - Chapter 8

Install the nut for the rockshaft sensor link assembly.

Torque to 18 to 23 Nm (14 to 17 lb ft).

Install the hitch lift cylinder as follows:

1. Pins must be clean and free of dirt, grease, oil

and anti-seize compound, etc.

2. Position a hitch lift cylinder into place. Insert the

bottom cylinder pin (groove outside) through the

mounting bracket and cylinder.

3. Attach the locking flag plate.

4. Tighten bolt to a torque of 82 to 106 Nm (60 to 78 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040