New Holland T8010 Manual page 937

STEP 37
Attach the hitch lift cylinder as follows:
1. Pin must be clean and free of dirt, grease, oil and
anti-seize compound, etc.
2. Move a hitch lift cylinder into place. Insert the
holding pin through the hole in the lower end of
the cylinder shaft and the shaft support.
3. Install the bolt, washer and spacer. Tighten bolt
to a torque of 82 to 106 Nm (60 to 78 lb. ft.).
STEP 38
I n s t a l l t h e t h r e e n u t s t h a t a t t a c h t h e h i t c h
potentiometer bushing to the sensor bracket and
sensor. Tighten to a torque of 3.5 to 6.3 Nm (2.6 to
4.6 lb. ft.).
NOTE: This step may not be required. If required,
refer to potentiometer assembly drawing, shown on
page 21).
Section 35 - Hydraulic Systems, 3PT - Chapter 11
36-28
36-15
35-11-16
STEP 39
Install the nut for the link assembly. Tighten to a
torque of 18 to 23 Nm (14 to 17 lb. ft.).
STEP 40
Install the two bolts that attach the linkage shield to
the hitch support arm. Tighten to a torque of 62 to 80
Nm (46 to 59 lb. ft).
36-18
36-21