New Holland T8010 Manual page 528

STEP 38
Turn nose of carrier down. Remove outer pinion
bearing cup as shown. Locate driver on back edge
cup; drive cup out of carrier if necessary.
NOTE: Do not damage the carrier bore.
Section 25 - Four-Wheel Drive Front Axle - Chapter 9
RR98K040
25-9-11
STEP 39
Install a split collet and press the bearing cone off of
the pinion shaft.
WARNING: Do not allow the shaft to fall. It
can strike legs or feet and may cause serious
!
injury. Gear teeth may have sharp edges.
Use care when handling to avoid injury.
NOTE: It is recommended that whenever bearings
are removed, they are to be replaced with new ones
(regardless of hours).
NOTE: If replacement of a damaged bearing cup or
cone is necessary, the cup and cone must be
replaced as a set.
RR98K036
M688