New Holland T8010 Manual page 591

Hide thumbs Also See for T8010:

Table of Contents

Remove the two sensor mounting screws and

remove the sensor from the bracket.

Loosen the set screw (1) and remove the sensor

Inspect the bushing for wear or damage. Replace the

bushing if necessary.

Section 25 - Four-Wheel Drive Front Axle - Chapter 11

Disassembly of the following parts is from location

Install a slide hammer into the swing arm cradle pin.

Move the pin out a small amount and remove the

Chapters

Table of Contents

T8020 T8030 T8040