New Holland T8010 Manual page 236

Hide thumbs Also See for T8010:

Table of Contents

Bearing Removal and Replacement

If the MFD shaft bearing must be replaced, press the

old bearing out of the housing. Press a new bearing

assembly into the housing until the bearing is flush

with the rear housing surface.

Press the bearing cup out of the rear output shaft

bearing cage if the bearing cone on the output shaft

has been replaced.

Section 21 - Transmission, Drivelines - Chapter 4

Press a new bearing cup into the cage until the cup is

fully seated.

Use a puller to remove the bearing cup from the rear

countershaft bearing cage if the bearing cone on the

countershaft has been replaced.

Press a new bearing cup into the cage until the cup is

fully seated.

Chapters

Table of Contents

T8020 T8030 T8040