Planetary Hub Disassembly - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Park the tractor on a hard, level surface. Put the

transmission shift lever in PARK. Turn the engine off

and remove the key. Place blocks in front of and

behind the rear wheels. Remove the front fenders

from the front axle, if equipped.

Raise the front axle. Install axle stands. Remove the

front tires.

WARNING: The tires on this tractor are very

heavy. Use a wheel remover or chain hoists

to remove and install the tires. Use additional

help as required.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

PLANETARY HUB DISASSEMBLY

Allow the axle to cool before servicing. Slowly open

the axle fill plug to release any internal axle pressure.

Remove the axle drain plug (1). Drain the axle oil into

a suitable, clean container.

Before draining the oil from the planetar y hub,

position the hub cover so the planetary hub drain/fill

plug (1) is at the highest position. Make sure the axle

fill plug has been loosened to release any internal

axle pressure. Loosen the planetary hub plug and

rotate the hub cover so the plug is at the lowest

position. Remove the planetary hub fill plug and drain

the oil into a suitable container.

Table of Contents

T8020 T8030 T8040