Installation
STEP 4
1
Install the two charge pump to hydraulic pump drive
mounting bolts. Install the charge pump outlet hose
(1) to the filter head. Install the outlet line to the
priority valve (2). Install the connector to the hydraulic
filter pressure sender (3).
STEP 5
2
1
Install a new O-ring on the suction hose flange.
When installing the charge pump, it will be necessary
to loosen the hose clamps on the rubber charge
pump suction hose and pry up on the hose to provide
needed clearance for the suction flange O-ring.
Install the two suction hose flange bolts (1) and
tighten the hose clamps. Install a new O-ring (2) on
the charge pump flange. Install the cover plate and
bolts.
STEP 6
Move the rear wheel inward on the axle. Apply
antiseize to the bushing bolts. Tighten the bushing
bolts to a torque of 300 to 350 Nm (220 to 260 lb. ft.).
Remove the axle support equipment and the front
wheel blocks. Check the hydraulic fluid level in the
tractor and add fluid as needed.
Section 35 - Hydraulic Systems, 3PT - Chapter 7
2
3
RD02D009
RD02D006
35-7-4