New Holland T8010 Manual page 513

Hide thumbs Also See for T8010:

Table of Contents

When backlash is adjusted properly, rotating torque

at the pinion shaft should be 5 to 10 lb. inch higher

than the torque you had when setting pinion shaft

bearing preload.

Install the adjusting ring clips, one on each adjusting

ring. Tighten adjusting ring clip bolts to a torque of 27

to 40 Nm (20 to 30 lb. ft.).

Section 25 - Four-Wheel Drive Front Axle - Chapter 8

Tighten all of the bearing cap bolts to a torque of 240

to 270 Nm (180 to 200 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040