New Holland T8010 Manual page 598

Hide thumbs Also See for T8010:

Table of Contents

Remove the snap rings that retain the spherical

bearings and remove the bearings. Inspect the

bearings for wear or damage. The cylinder must be

replaced if either is present.

Remove the shoulder bolts from the cylinder

mounting pins.

Use a puller or slide hammer and remove the

mounting pins from the housing.

Section 25 - Four-Wheel Drive Front Axle - Chapter 11

Remove the seals from the housing. Inspect the

bores for damage.

Remove the thrust washers.

Use a driver and remove the bushing from the bores.

Chapters

Table of Contents

T8020 T8030 T8040