New Holland T8010 Manual page 231

Hide thumbs Also See for T8010:

Table of Contents

Install the reverse speed driven gear as follows:

1. Install a new seal ring on the reverse speed

driven gear.

2. Align the friction plate teeth.

3. Install the reverse speed driven gear into the

clutch pack. The splined hub of the gear must be

facing down. Slight oscillation of the gear will

help with the installation.

NOTE: The splined hub of the gear must engage all

the friction plates.

Install the spacer in the gear hub. Install the caged

needle bearing into the gear hub.

Section 21 - Transmission, Drivelines - Chapter 4

Install the needle thrust bearing and the two bearing

thrust washers.

NOTE: The needle thrust bearing must be between

the two bearing thrust washers.

Install the front bearing cone with the smaller OD end

of the bearing cone facing up. Press the bearing on

the inner race to properly seat the bearing on the

Install four new seal rings on the shaft.

Chapters

Table of Contents

T8020 T8030 T8040