New Holland T8010 Manual page 487

STEP 19
1
Install the two tie rod support plate retaining bolts (1)
on both sides of the axle. Tighten the bolts to a
torque of 300 to 550 Nm (225 to 405 lb. ft.). If
removed, install the tire rod ends. Tighten the castle
nut to a torque of 373 Nm (275 lb. ft.) then advance to
the next slot in the nut. Tighten the tie rod adjusting
nut to 373 to 441 Nm (275 to 325 lb. ft.).
STEP 20
Use proper lifting equipment to install the front weight
bracket. Tighten the four retaining bolts to a torque of
662 to 851 Nm (488 to 627 lb. ft.).
Section 25 - Four-Wheel Drive Front Axle - Chapter 7
1
RD02C024
RD02B159
STEP 21
2
1
Using the identification tags from the disassembly
procedure, install and tighten the cylinder supply
hose (1) to each cylinder. Install and tighten the two
front axle differential lock hoses (2) to the axle cover.
STEP 22
Install the front wheels. Apply a thin coat of antiseize
to the front wheel studs. Tighten the wheel stud nuts
to a torque of 385 to 425 Nm (285 to 315 lb. ft.).
25-7-8
RD02B158
RD02B157